18” STANDARD Roof Riser Bracket, KIT (Includes Lateral Stabilizer and 1.50" UPF Flashing"
NOTE: KITS ARE COMPLETE SINGLE SKU ITEMS. REFUNDS NOT AVAILABLE ON AN ITEMIZED BASIS.
Our 18” standard duty roof riser bracket extensions feature professionally-engineered construction and a black, powder-coated finish. Designed to easily increase the height and/or pitch of most patio, deck, and pergola roof coverings, our 18” heavy duty, black powder-coated brackets can attach to rooftops, building sides, and more. The SkyLift hardware brackets are a simple, secure, and sealed roof attachment method to increase the height and/or pitch of your patio, deck, or pergola roof cover.
Use with 1.50" LIFETIME ULTIMATE FLASHING
About our 18” Roof Riser Products
The SK18-B Standard Duty riser package includes the following components:
- 18" standard riser base with receiver on top
- 3-1/2" Saddle
- 1.5" UPF 150 Flashing
- LSS 1.5 Lateral High Wind Strap
- Structural screws
- Structural nuts
- Simpson SDS screws for riser base
- Simpson SDS screws for top of the saddle
- Heavy duty rubber washer
- T40 Torx bit for SDS screws
Roof flashing add-on is not included in bracket purchase and should be purchased additionally for a fully-sealed riser installation.
For a full DIY project, shop our additional installation products here.
ModelSK18-B
Color/Coating
Powder Coated Black
Material
Sch 40 Steel pipe, Cold Rolled Steel
Dimensions
Post Size: 1-1/2" x 18"
Plate: 1/4" x 3-1/2" x 6"
Saddle: 4-1/2" x 3-1/2"x 4-1/2"
Weight: 8.6 lbs.
Fasteners for base
1/4" x 3" Simpson SDS Structural
Included
Fasteners for saddle
1/4" x 3" Simpson SDS Structural
Included
Fastener for collar
3/8" x 2-5/8" Galv. Bolt/nut
Recommended Uses
Patio Cover support
Trellis support
Secondary support
Gabled patio support
Secondary deck support
Other
Not to be used as primary means of lateral loads
Not to be used over unsupported structures
Not to be used in excess of wall or beam carry capacity
Intended to be installed over double top plate wood framed wall construction
If use over concrete or CMU block verify conditions and used approved anchors/fasteners
A single standard duty SkyLift roof riser bracket package comes with a one-piece base and riser, one detachable saddle, one grade 5.3/8, 16 x 2.75 zinc plated bolt and 12 Simpson Strongtie SDS 1/4" x 3" screws. Additional items not included that you will need: one standard roof jack flashing.